Jump to content

Sharp PC-1403

From Wikipedia, the free encyclopedia

Sharp PC-1403
Sharp PC-1403 handheld BASIC computer
TypePocket computer
Introduced1986
Calculator
Entry modeInfix, BASIC,
Display typeLCD dot-matrix
Display size24 characters
CPU
ProcessorCPU: Hitachi SC61860 (8-bit CMOS)
Frequency768 kHz
Programming
Programming language(s)Unstructured BASIC
User memory8 KB
Firmware memory72 KB
Interfaces
Ports1x proprietary (11 pins)
Other
Power supply2x CR2032
Power consumption0.03 W

The Sharp PC-1403 was a small scientific calculator and pocket computer manufactured by Sharp. It was the successor of the Sharp PC-1401, and had better display, more RAM and better system software.

Technical specifications

[edit]
  • CPU: Hitachi SC61860 (8-bit CMOS) 768 kHz
  • Memory: 8 KB RAM (6863 bytes available), 72 KB ROM; 32 KB RAM in PC-1403H model
  • Display: Monochrome LCD 1 line with 24 5×7 characters
  • Power: 6 V DC - 2× CR2032, 0.03 W
  • Connector (11 pins) for external devices
  • Integrated speaker (4 kHz beep only)
  • Contrast adjustment wheel
  • Software: Simple BASIC interpreter; calculator mode
  • Matrix calculations

Manufacturing started in 1986.

It is possible to convert the 1403 to a 1403H by removing the 8 K RAM and soldering in a 32 K RAM. An inverter IC is needed for this, too.

Calculator

[edit]

Calculations could be performed in two modes CAL and RUN.[1] In the former, the PC-1403 would behave like a normal scientific calculator at the time with formulas entered in algebraic logic. In RUN mode, BASIC statements could be entered for immediate execution and print out. The latter was similar to the Direct algebraic logic employed by modern calculators.

Programming

[edit]

The programming model employed was unstructured BASIC for which the PC-1403 distinguished between RUN and PRO mode. The later being used to enter and edit program and the former being used to execute them.

Programming example

[edit]

Here is a sample program that computes the factorial of an integer number from 0 to 69. It can be called by entering a number or an expression followed by pressing DEF F (in run mode).

10 "F" AREAD N                         ''allows to start the program with <expression> DEF F
20 F=1                                 ''Set start value of F to 1
30 FOR I=1 TO N                        ''counts I from 1 to N
40 F=F*I                               ''calculates F=F*I
50 NEXT I                              ''repeats loop from line 40
60 PRINT STR$ N+"!=";F                 ''print result - i.e. 5!=120.
70 END                                 ''end of program

Machine language programming

[edit]

It is possible to write machine language programs into memory using the POKE command and starting them with the CALL command.

See also

[edit]

References

[edit]
  1. ^ SHARP Pocket Computer Model PC-1403 - Operation Manuel (PDF). Osaka, Japan: Sharp Electronics / Sharp Corporation. 1986. Archived (PDF) from the original on 10 September 2016.